Features:

- Screen size 4 inch

- Spectrum Analyzer for 0.1-800MHz or, with Ultra mode enabled, 0.1MHz-6GHz

- Signal Generator with sine wave output between 0.1-800MHz or dual tone output up to 4.4GHz when not used as Spectrum Analyzer.

- Switchable resolution bandpass filters for both ranges between 200Hz and 850kHz

- Built-in 20dB optional LNA

- Color display showing 450 scan points covering up to the full frequency range.

- Input Step attenuator from 0dB to 31dB (not in combination with LNA).

- A built-in calibration signal generator that is used for automatic self test and (low) input calibration.

- Connected to a PC via USB it becomes a PC controlled Spectrum Analyzer or Signal Generator

- Rechargeable battery allowing a minimum of at least 2 hours portable use

- Max input level +10dBm. Do not destroy your tinySA

- Due to the low cost and very small form factor there are certain relevant tinySA limitations and tinySA Ultra limitations

 

Specification：

Parameter	Specification
Display size	4” TFT LCD (480×320)
Max low input frequency	800MHz, 6GHz in Ultra mode
Resolution filters in 1,3,10 steps	from 200Hz to 850kHz
Max output frequency	Sinus up to 800MHz
output level	-104dBm to -16dBm
Ultra mode	Level calibrated up to 5.3GHz
Internal LNA gain	20dB up to 4GHz
Displayed points per scan	max 450
0-350MHz scan time	165ms
Shortest zero span time	17ms
DANL at 100MHz	-153dBm/Hz (LNA Off) / -169dBm/Hz (LNA On)
DANL degrading in ultra mode	10dB above 2.5GHz, 25dB above 5.3GHz
Phase noise at 10kHz bias	-92dBc/Hz
Phase noise at 100kHz bias	-110dBc/Hz
Input 1dB compression level	+0.5dBm (LNA Off) / -26.5dBm (LNA On)
IIP3 without LNA	+18dBm (at least 2MHz apart) / 0dBm (500Hz apart)
IIP3 with LNA	-8dBm (at least 2MHz apart)
Frequency stability	<1ppm ( -10℃ ~ +55℃)
SD card slot